100" Kvaerner-Hymac Wet Lap Machine

  

Complete Wet Lap Machine - Wire Section, Press Section & Cutter Layboy with Vacuum System 


Recent Upgrades: (Andritz)

Flotating Wedge with Side Deckle Assembly, Wire Tensioning Device, Sheet Transfer Device to For Pulp Sheet from Twin Wire Press to Cutter Layboy, Wire Cleaning Shower, T.W.P Frame Extension and Supports, (4) Additional "S" Rolls, Independent Foil Section, Roll Doctors, Dewatering Barrier, Grooved Roll Showers and Wipers, Headbox Dilution Shower 

System Components:

Pneumatic Control Panel, Instrumentation Tubing, Switches and Components, Blower and Ducting for Vacuum Transfer System above Stacker, All Drive Motors and Gear Reducers for the Driven Sections of Machine, Pumps and Agitators at White Water Chest and Pulper, Stock Flow Control Valves and Flow Meters, U-Tube Piping, Hydraulic System, Monorails and Chain Hoists, Hood, Ducts and Roof Fan, Spare Rolls and Fabrics

 


Twin Wire Press

 

Hymac Model 100HP-8f for Continuous Dewatering of a Variety of Pulps and Slurries.   Cantilevered Frame Design for use with Endless or Seamed Belts. 

  

(6) Press Rolls- Carbon Steel with Hard Rubber Coverings. Mounted in Carbon-Steel Pillow Block Housings (2) Drive Rolls with Variable Speed AC Drive and Dual Output Gearbox 

 

 

Photo 1: (2) Pneumatically Actuated Automatic Tracking Systems for both Upper/Lower Belts. Photo 2: Fixed Type, Stainless Steel Water Doctors 

  


Cutter Layboy 

Hymac Cutter Layboy Unit for Wet Sheet Cutting and Stacking- Fabricated Tubular and Plate Carbon-Steel Framing, Stacking/Transfer Table: Belt Conveyor, Scissor Lift, Machine-Direction Discharge

 

 

Photo 1:Sheet Split and Trim Unit -High Pressure Water System for Side Trim & Center Cut.    Photo 2: Knife Entry Belt (Conveyor)- Receives and Feeds the Sheet from the Press to Cutter

 

 

Fully Automatic Finger Table to Hold Incoming Sheets During Transfer of Load from Stacking Table

 

 

Additional Photographs, Technical Documents and Drawings